Make Your Own LED 12 volt Lights for Motorcycles

Now the technology is more advanced, so did the light. Ancient halogen lamp with yellow filaments are still popular, but now has been replaced with white LED lights and TL lighter and power-efficient. LED lights also give the impression of luxury on your motorcycle.

 

If you want to feel the white light on the front or rear headlights, brake your bike, maybe my post can help this time.

LED lights on motorcycles was already available motorcycle accessories stores, but if the results are not satisfied you can experiment yourself to make the LED light assemblies.

How to make your own LED lamp is very easy. The cost is also very affordable.
Let's look at the steps in making a series of LED lights 12volt motorcycle

Required :
- White color LED lights 4 pieces
- Resistor 330 ohm 2 pieces
- Former halogen bulbs
- Solder, tenol, multitester, adapter 12volt

After all the ingredients are ready, raft LED lights as shown below :

The flow of the circuit like this :

If completed assemble, test the lights with 12volt adapter is on or not with 12-volt adapter.

Make sure the LED lights in the correct installation, if reversed the positive pole (+) and negative (-) it, the lamp will not light. If the resistor is not the opposite problem.
There are actually 2 series. The circuit consists of resistors 1 and 2 LEDs in series.

If still not bright, you can make 3 series (6 LEDs) or more. Or you can substitute smaller resistor values ​​like 270 ohms, but will not be long lifespan LED.

A few tips from me, if there is less clearly understood and not be questioned via the comments below.

Posted in: Other